Ürün Açıklaması
Tek kafalı sistem
General specifications
Sensing range150 … 2500 mm
Dead band0 … 150 mm
Standard target plate100 mm x 100 mm
Transducer frequencyapprox. 120 kHz
Electrical specifications
Operating voltagefor UART and PWM operation:
UUART/PWM = 2.5 … 5 V DC, typical 3.3 V
for LIN operation:
ULIN = 8 … 18 V DC, typical 12 V
No-load supply current≤ 60 mA at 3.3 V DC
≤ 20 mA at 12 V DC
Quiescent current indication< 3 µA during standby mode at UART- and PWM operation
Power consumption≤ 250 mW in the measurement operating mode
Time delay before availability≤ 70 msInterface 1Interface typePhysical LIN interface
Transfer rate19.2 kBit/s (8N1)
Cycle time55 ms
Resolution10 mm (corresponding to 1 LSB)Interface 2Interface typeUART 3.3V
Transfer rate19.2 kBit/s (8N1)
Cycle time55 ms
Resolution10 mm (corresponding to 1 LSB)InputInput typeStandby active
Signal levellow: 0 ... 0.8 VOutputOutput typePWM output (PNP) , not short-circuit protected
Resolutionpulse length 10 µs /cm
Output rated operating currentmax. 10 mA
Temperature influence3 % of full-scale value over the entire temperature rangeDirective conformityElectromagnetic compatibility
Directive 2014/30/EUEN IEC 60947-5-2:2020 : chapter 8.2.6.2.2, 8.2.6.2.3, 8.2.6.3
The sensor is designed to be supplied by a battery. The sensor signals are further processed in a control unit, which is also responsible for EMC protection.Ambient conditionsAmbient temperature-25 ... 70 °C (-13 ... 158 °F)
Storage temperature-40 ... 85 °C (-40 ... 185 °F)Mechanical specificationsConnection typefixed cable with plug
Degree of protectionIP66 / IP67 ( connector excluded )
Material
HousingPBT
Transducerepoxy resin/hollow glass bead mixture; Polyurethane foam, PTFE coated
ConnectorMolex connector 70107-0007
Number of pins8
Cable
Length276 mm ± 20 mm
Mass100 gFactory settingsOutputPWM output (PNP)
Temperature compensation
Address setting 7
Beam widthwideGeneral informationScope of delivery2 nuts plastic
